Veterinary X Ray Machine-Veterinary Equipments-Products-ANJUE MEDICAL

Your position：Home > Products > Veterinary Equipments > Veterinary X Ray Machine

- AJ-VX400
  
  Veterinary X Ray Machine

32kW 400mA Veterinary X Ray Machine AJ-VX400

(Suitable for Big Animals)

32kW 400mA Veterinary X Ray Machine Digital Type with Wireless Flat Panel

32kW 400mA Veterinary X Ray Machine Digital Type with Wired Flat Panel

32kW 400mA V Mobile Veterinary X Ray Machine Analog Type

32kW 400mA Veterinary X Ray Machine Digital Type Parameters

Power		32kW (can take clear images for the body no more than 50cm thickness )
Power supply		Single-phase,220V 50/60HZ (wire diameter>4mm², internal resistance<0.5Ω)
mA		10~400 mA
mAS		1~400mAS, stepping by R’10
KV		40~125kV, stepping by 1kV
Exposure time		0.003~6.3S adjustment: Increased /reduced by 1mS each time
X-ray tube		Chinese brands Mingwei M7110 are available or Toshiba tube for options .0.6-1.2mm double focus
Anode rotating speed/Anode heat capacity		2800prm/140kHU
Generator frequency		400kHz
Radiography table(W*L cm)		Width: 70cm, length: 140/120cm (either) urinary trough can be equipped with
Flat panel detector	Imaging area	1717 inches (or 1417 inches) (wired and wireless)
	Pixel size	140um
	A/D conversion	16bits
	Spatial resolution	3.6lp/mm
Software		Veterinary software
Computer configuration		Intel i5 processor; 8G memory, 2G discrete graphics card, 128G solid state drive + 1TB mechanical hard drive, PCI-E and Ethernet dual Gigabit network cable interface, R232 interface; 22.5-inch Dell professional small dot pitch monitor; operating system: win10

Digital Images

*Images from different brand X-ray tube

(Toshiba 7242 tube 50kv 0.8mAS ) (Chinese brand tube 50kv 0.8mAS)

*High quality flat panel dector with good performance to present item’s details

(Picture shows high-contrast rendering of fishbone fine fibers)

(Picture shows Animals Belly Image)

Installation Instructions

1. X-ray room: 20m² room is recommended.

2. Lead glass size recommended: 40*60cm or 60*80 cm

3. X-ray protection preparation: use barium sulfate powder or lead sheet for the wall of the room, and lead sheet for the ceiling;

4. A fan must be installed on the top to facilitate the discharge of ionized air

5. All surfaces of the x-ray room that people can reach need to be covered with lead sheet or barium sulfate powder. If it is the first floor, the ground does not need to be covered; if it is the top floor and will not polluted the environment, lead protection is not required.